For example, the VISTA-15P and 20P will need to be revision 9.12 or higher since that is the earliest revision to support RIS. The 4232CBM requires RIS (Remote Interactive Service) to be supported and enabled on your VISTA series alarm panel. For newer Z-Wave controllers without these antiquated serial ports, you may have to source an adapter from DB9 (serial) to USB or whichever connection your controller supports. These systems are connected using the Serial connection with RS232 or RS422 data protocols between the automation system and the alarm panel's ECP bus. Referred to as the Connected Building Module, the 4232CBM allows you to tie your VISTA security system in with a variety of third-party home automation controllers such as Control4, Crestron, Savant, Lutron, URC and Key Digital. The shades data table layout is as follows:Īddress 1 = The blind motor address in decimal format.The Honeywell 4232CBM is a home automation system interface module for the VISTA Series alarm control panels. RJ-45 Pin 4 (Gnd) -> "GND" terminal on the Somfy controller. RJ-45 Pin6 (TX-) and Pin2 (RX-) -> RS485 "-" terminal on the Somfy controller. RJ-45 Pin3 (TX+) and Pin1 (RX+) -> RS485 "+" terminal on the Somfy controller You need to convert each byte in this address to it's equivalent decimal value and then place each value in the shades data table according to the notes below. This address goes into Address 1 of the shades data table.Įach Somfy blind controller has a three byte address printed on the top expressed in Hex. Each blind motor has it's own address on the controller. Either:ġ> Use a Savant controller that supports RS485 such as an SSC-0025Ģ> Use an RS-232 to RS-485 converter between the Savant hardware and the Somfy blind controller.Įach Somfy blind controller can handle 16 blinds.
This means that you need to choose your interface hardware very carefully. Not all Savant controllers support RS-485 They use RS-485 and that's a very important distinction to be observed as these two communications protocols are not compatible or interchangeable. These devices provide no feedback and have only a receive channel. You need to use the device profile named "somfy_rs485 rts transmitter". We, we have tested these device and found the following.
0 kommentar(er)
